| What's
the Problem |
Is
this the Cause |
Here's
the Solution |
| 1)
Customer inserts token into coin mechanism and it does
not register on the display panel. |
1a)
Token in coin return |
1a)
Pull token out of coin return and try again. |
|
1b)
Token stuck in coin mechanism. |
1b)
Open coin mech, by pinching the two tabs together and
pulling. Mechanism will hinge out, then dislodge token.
|
|
c)
Wire whisker on coin mechanism microswitch needs adjustment.
|
1c)
If coin is not registering, bend wire in manner to make
it longer. If multiple counts are registering from one
coin, bend the wire in manner to make it shorter. |
|
1d)
Defective coin mechanism microswitch. |
1d)
Unplug the two wires connected to the microswitch and
touch them together then release, if nothing registers
on display panel call ABC. |
|
1e)
Wire in coin box is bad. |
1e)
Inspect wire going to microswitch for nicks, cuts, or
pinches. Repair as needed. |
